Only Getting 450 Mbps on a 1 Gbps Wired Connection

ChaZz182

10 hours ago

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2025-12-10

Only Getting 450 Mbps on a 1 Gbps Wired Connection

10 hours ago

Tags:

Model: Archer AXE75

Hardware Version: V1

Firmware Version: 1.4.1 Build 20250717 rel.40472(4341)

I'm not very good a networking, so please forgive me if I use the wrong terminology.

I just got 1 Gbps internet, but I'm only seeing around 450 Mbps on my computer which is connect via a wired connection. If I bypass my AXE75 router and connect my computer directly, I get the correct speed.

I have done a bit a googling and have tried a few of the suggestions I have seen. I have checked the cables (cat 5E), the QoS and tried different ports with no luck. Is there anything or any setting that I'm missing?

The ports all show 1000 Mbps Full Duplex.

1 Reply

terziyski

LV7

9 hours ago

Posts: 7907

Helpful: 6365

Solutions: 1541

Stories: 7

Registered: 2013-10-12

Re:Only Getting 450 Mbps on a 1 Gbps Wired Connection

9 hours ago

@ChaZz182

From your description it seems like this is caused by a setting on your AXE75.

Back up your AXE75 config then reset its configuration by pressing the reset button for about 10 seconds.

Configure only the basic settings (Internet connection type, LAN IP address, etc.) and test again to check if there's any difference.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Only Getting 450 Mbps on a 1 Gbps Wired Connection

Only Getting 450 Mbps on a 1 Gbps Wired Connection

Information

Voters 0

Tags