Wireless
I have this AP in the attic, face down on the dry wall. Its sitting on 2 1" x 1" pieces of wood for airflow. All the insulation is cleared away. I have 3 other APs around the house all on non overlapp
Wi-Fi 7
0Helpful
138Views
I need the release notes for the newest firmware 1.1.7 Build 20260305 Rel 22561
Firmware UpdateAFCWi-Fi 7
By
conjohnstantine
· Latest post Thursday
by Vincent-TP
0Helpful
128Views
I have constant Internet dropouts on my WiFi network and even connecting to the WiFi itself ( it appears as connected but no internet access ), takes sometimes up to a min, this forces me to use my mo
Network ConnectivityWi-Fi 7EAP772
0Helpful
209Views
Hi all, I assumed that the WiFi Regulatory Domain for my EAP Access Points would follow the country setting for the site, but that seems not to be the case. Is that expected behaviour - is there anoth
Wi-Fi 7Wi-Fi 6EAFC
By
Landfall2624
· Latest post 2 weeks ago
by Vincent-TP
1Helpful
1128Views
Does anyone here know if the omnidirectional and directional antennas of this device can be used simultaneously? There's a launch offer, but I'd like to know if I can use all the antennas at the same
Network ConnectivityPresalesWi-Fi 7eap725-outdoor
0Helpful
552Views
We are using an EAP723. Previously, when using the Omada controller v5.8.3, there was no packet duplication (DUP) issue when pinging. When we tried migrating the controller from Omada v5.8.3 to Omada
Network ConnectivityFirmware UpdateWi-Fi 7
By
RTO888
· Latest post 2026-03-16 06:02:20
by Vincent-TP
0Helpful
254Views
Hello, How can I verify that the EAP773 is negotiating the correct 10 Gbps speed with the Mikrotik SFP+ module and that there are no communication errors? The EAP773 is powered by a 12V 2.5A power ada
Wi-Fi 7TopologyNetwork Connectivity
By
PavelV
· Latest post 2026-03-10 07:45:39
by Vincent-TP
0Helpful
351Views
I run Omada Controller on a Windows 11 25H2 PC. I recently turned it into a service using the official instructions. After rebooting, I can access the Omada Controller instance just fine but my EAP787
Wi-Fi 7
By
jdrch
· Latest post 2026-01-14 06:53:30
by Vincent-TP
1Helpful
352Views
Hello All, Hoping I can get a bit of advice as I am not sure what to try next. I have 1gb internet via ISP Router connected to a TPLINK SG2428P Switch. I have 2 x EAP773 access points (one upstairs an
Network ConnectivityWi-Fi 7
By
FartingSpartan
· Latest post 2025-12-11 03:36:59
by Vincent-TP
0Helpful
431Views
I have two EAP773 where MLO is working perfectly - I recently added a EAP770 and copied the same settings to it but the clients will not connect to it with MLO. If you reboot the AP you will see the c
MLOWi-Fi 7
By
BigGuyFi
· Latest post 2025-12-10 08:50:18
by Vincent-TP
1Helpful
956Views
Hi, I recently bought an EAP772-Outdoor (US) v1.0 AP from my local distributor in Singapore. While setting up, I realized there is no way to enable 6Ghz wifi. By default, AFC is enabled, but I get the
Network ConnectivityWi-Fi 7
By
terencelzw
· Latest post 2025-11-27 22:50:20
by Javito
8Helpful
8231Views
This Article Applies to EAP770/EAP783 Hi Everyone, We’re excited to announce the official launch of EAP770/EAP783 here! EAP770/EAP783, the Omada BE11000/BE19000 Ceiling Mount Tri-Band Wi-Fi 7 Access P
Wi-Fi 7
12Helpful
27894Views