How uni or omni directional are the EAP 245's?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

How uni or omni directional are the EAP 245's?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
18 Reply
Re:How uni or omni directional are the EAP 245's?
2020-03-24 00:19:41

@Marketroid 

 

From the picture, we can see that the area with the best signal is 60, when it is about 74 degrees, the signal will be a little weaker. So if it is 80 degrees in your area, the clients can still access the internet, but they will not have the best signal. So please make sure that the clients are not far away from the AP. 

  0  
  0  
#12
Options
Re:How uni or omni directional are the EAP 245's?
2020-10-11 00:43:28

Sorry to bump this old thread @jonas.

 

Also calling in expertize of @Fae  and @R1D2 .

 

What AP power level was assumed for these recommendations?

 

What frequency band was used for these recommendations?

 

What client device was used for these numbers?

 

Looking for numbers for 5GHz band (UNII-1 and UNII-3), with medium power on EAP225 and for a typical Smartphone (Apple, Samsung) in a larger mostly open area with average AP height of 6 meters and estimated 40 APs (AP to AP distance of about 70 feet). Looking to only provide about 10Mbps up and down speeds.

 

Thanks

  0  
  0  
#13
Options
Re:How uni or omni directional are the EAP 245's?
2020-10-11 20:32:29

@dpsguard,

 

I think those recommendations are derived from the EAP's antenna radiation patterns.

Antenna radiation patterns do not depend on power levels or client devices.

 

If the Tx power is high, attenuation in dB at the edges of the covered area will be the same as if Tx power would be medium. Of course, absolute values differ.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#14
Options
Re:How uni or omni directional are the EAP 245's?
2020-10-11 21:26:52

@R1D2 

 

Yes I can understand that attenuation does not change, but they were talking about 15 meters range and having smartphones having difficult time at that range, so they must be talking of absolute signal level as well.

 

I can assume that these figures are for 2.4Ghz and with default high power. My own but couple of years old experience using Cisco 1800 series APs mounted at about 20 feet high in such environment with 17dBm power (using UNII-3 channels, power level 1 (max), which also has higher power in North America, but UNII-1 channels at least in Cisco level 1 is like 11dBm), was that I could get about 50 feet (was with Samsung Note 8). I do find that iPhones have issues in connecting with 5GHz unless they really have signal level better than -70dBm. So I was assuming 40 feet will be better range to ensure best coverage when set to medium power. I cannot go to test (COVID issues and building closed) and have to provide my ballpark figures. So I arrived at 40 APs with AP to AP distance of about 70 feet.

 

Thanks

 

  0  
  0  
#15
Options
Re:How uni or omni directional are the EAP 245's?
2020-10-11 21:49:27 - last edited 2020-10-11 22:00:54

@dpsguard, the post talking about »15m recommended coverage area« is mis-understanding in my opinion.

 

There is no »recommended coverage area«, since actual coverage in the real world depends on so many influences at the location as well as on the Tx power of each client device, so one  can not predict the coverage area, only give a roughly estimate.

 

The diagram allows to calculate the covered area with best signal strength (if there is a free line of sight) depending on the mounting height of an EAP. This is not to be confused with the actual area covered by the EAP. Reflections of microwaves will extend the covered area, but distant clients will negotiate much smaller WiFi rates.

 

It is not even possible to calculate properly where microwaves of an EAP are going and where they can no longer be received. You can only measure this, e.g. with a heat mapper. In our country, radio technicians have a saying: The love and the behavior of radio waves are unfathomable.

 

The recommendation from TP-Link is that if you have neighboring EAPs at a distance < 15m you might need to decrease Tx power in order to avoid interference. But even this depends on the actual location and must be measured for each single EAP (Omada controller provides statistics for this purpose), so in fact the EAPs could at one location probably as near as 10m to each other w/o interfering since there are obstacles or at another location they can be 20m apart from each other and still interfering, e.g. in a conference room.

 

Sorry for the metric units, my feet are maybe bigger or smaller than yours. Just some fun. :-)

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  1  
  1  
#16
Options
Re:How uni or omni directional are the EAP 245's?
2020-10-11 22:04:10

@R1D2

 

yes I fully understand that there are so many variables, but for planning purposes, to even get a budgetary numbers, we need to start somewhere. Sure I can use Ekahau Pro planning tool, but I was trying to see if someone had already deployed and what their findings in the field are. If building was open I would have gone there with a tech to mount the AP up at 2 feet and then measure around with a typical cell phone and then installed two more APs around and then test some roaming around also with AP to AP distance of about 70 feet.

 

I think for now, I am going to stick with my plan of about 40 APs to provide smartphone grade 10Mbps speeds.

 

Thanks again for your excellent help.

  0  
  0  
#17
Options
Re:How uni or omni directional are the EAP 245's?
2020-10-11 22:49:51

@dpsguard, you're right, it's difficult to plan this in advance.

 

Maybe we can discuss further in a few days, I'm swamped with work tomorrow and have to plan just a similar installation. For the ease of planning, I'll place an EAP every 10 meters (30 feet?), but there are obstacles (2 to 3 walls between rooms). So in an open space I would plan EAPs each 15 to 20m.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#18
Options
Re:How uni or omni directional are the EAP 245's?
2021-09-28 16:05:36

So just that you know: I'm using two EAP 245 in my house in a wall-mount configuration. It is a shame that tp-link does not provide an official wall mounting access point with similar throughput rates. Anyhow, I find the coverage even "behind" the EAP 245 decent.

 

However, I wondered what the best position for an EAP is, as I bought a third one for my workshop, where the house's AP's signal is not sufficient anymore on 5Ghz.

 

Judging from the picture on the first page, I think using the EAP on the wall is still the best solution if the ceiling height is not that big (2.25m in my small workshop).

  0  
  0  
#19
Options
Related Articles