DHCP reservation for Omada EAP

Re:DHCP reservation for Omada EAP
2021-10-15 07:15:19

@BartekJ 

You should read the whole thread?

The web admin let's you assign IP reservations 

0
0
#32
Options
Re:DHCP reservation for Omada EAP
2021-10-15 07:28:45

@Zedan_ises 

Based on replies yes, but not for Omada devices, like APs, Routers and switches, has this changed? 

0
0
#33
Options
Re:DHCP reservation for Omada EAP
2021-10-15 07:54:29

@BartekJ 

Well... it works for my OC-200... I don't know what device you are looking at?

0
0
#34
Options
Re:DHCP reservation for Omada EAP
2021-10-15 08:20:59

@BartekJ 

Let's try this again, with a more highlighted image

0
0
#35
Options
Re:DHCP reservation for Omada EAP
2021-10-15 08:56:16 - last edited 2021-10-15 08:58:11

will give this a try afternoon - a few months ago that did not work for APs or Router, switch wasn't visible on controler either.

 

On the router I have all visible:

 

0
0
#36
Options
Re:DHCP reservation for Omada EAP
2021-10-15 09:26:36

@BartekJ 

Just make sure you use the Web-Interface via Omada-Cloud interface

As far as I know, it's not possible on the UI of the Router itself.

0
0
#37
Options
Re:DHCP reservation for Omada EAP
2021-10-15 18:56:01

@Zedan_ises 

Almost all worked, so thanks a lot! One thing is missing - I have manageable switch (TP Link), not Omanda controller, but it is not listed on the devices list, which is a mistake, how to assign to it static IP?

0
0
#38
Options
Re:DHCP reservation for Omada EAP
2021-10-16 08:26:39
Then it's most likely not supported ... You would have to look it up on TP-Link Website
0
0
#39
Options
Re:DHCP reservation for Omada EAP
2021-10-18 10:19:06

@Zedan_ises 

Switch cannot be controlled by Omada and I know that, but it should be visible on devices list, to assign to it static IP, like that was on router page (and nothing else) - so I can see still some gap.

0
0
#40
Options
Re:DHCP reservation for Omada EAP
2021-10-18 12:59:05

@BartekJ 

 

Only clients served by OC-200 DHCP will show in the "Clients" list. It's not intended as a Network-Sniffer for unassigned clients with Static IPs.

 

My Netgear Managed Switch doesn't show in my "Clients" or "Devices" list, but I gave it an IP outside the reservation range. Assign your Router/Switch outside of the DHCP range and you should not encounter any difficulties.

 

Or, if you can configure your Switch to obtain it's lease via DHCP, it will show in the "Clients" list where you can then assign it a Static. My Netgear does not support dynamic IP assignment.

 

 

 

0
0
#41
Options
Related Articles