Omada - Only show VLAN SSIDs on managed switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada - Only show VLAN SSIDs on managed switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada - Only show VLAN SSIDs on managed switches
Omada - Only show VLAN SSIDs on managed switches
2021-01-07 00:52:18 - last edited 2021-01-07 00:54:00
Model: EAP235-Wall  
Hardware Version: V1
Firmware Version: 1.0.2 Build 20200917 Rel. 54331

I have just purchased this EAP235-Wall device to become part of a setup mixing EAP110, EAP115 and EAP225 devices.

 

I am using software controller v3.2.7 as the latest version supported by the oldest AP.

 

The EAP110 and EAP225 are connected to unmanaged switches, the EAP115 and the new EAP235-Wall are connected to managed switches.

 

If I add an SSID using a VLAN, it broadcasts across all APs, so there is no connectivity if clients connect to the VLAN SSID on APs connected to the unmanaged switches.

  

Does anyone know of a way to limit broadcast of VLAN SSIDs on the Access Points that are connected to the managed switches?

 

Thank you,

 

Neil

  0      
  0      
#1
Options
1 Reply
Re:Omada - Only show VLAN SSIDs on managed switches
2021-01-07 18:06:40

@NeilB 

 

Hey Neil

 

I have not used v3 of the controller so excuse if this is not the same as v4  -  had a look at the emulator for OC200

 

However i believe you can go to the AP specifically and choose to enable / disable the broadcast of specific SSIDS on that AP.  That might be an option for you?

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 435

Replies: 1

Related Articles