Client Not Showing in Omada SDN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Client Not Showing in Omada SDN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I have a strange bug: I have a client (Raspberry Pi running Raspbian 10) that is not showing up in my client list on Omada. The client is located in "Clients 4" below:
I can ping the Omada SDN and TL-R605 successfully from this client, and it is functioning properly in my network.
Has anyone perhaps seen similar problems, or have any tips for debugging?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@symbiotic_ic we have the same problem. I have a lot of lan devices and they are not showing up. sometimes they would show then disappear for a long time. I hope tp-link fixes it in the next update
- Copy Link
- Report Inappropriate Content
Thanks for the feedback. It's unfortunate we have this problem, but now I know that it's perhaps not just something on my end that I'm doing wrong.
- Copy Link
- Report Inappropriate Content
I have the same problem, apparently only for hard wired clients. I used to have the problem for wireless as well but it was fixed by upgrading controller to 2.4.11. The clients/managed switches suddenly vanish from the list and appear back in few minutes. At times, the list starts with a few items, and then suddenly grows.
In the logs (under Events), it is showing that my managed switches and some other wired clients disconnect with this message:
5E-3C-22-41-D0-85 was disconnected from network "LAN" on Router(connected time:18m connected, traffic: 0Bytes).
Just to connect back after 4 minutes:
5E-3C-22-41-D0-85 is connected to Router on LAN network.
The funny thing is that while typing this, the machine I am using suddenly appeared in logs as disconnected and disappeared from clients list, however, I'm fully connected and even internet connection works fine.
To me, it is purely a software glitch in Tl-R605. I'm running firmware 1.0.0 Build 20200930 Rel.36519
- Copy Link
- Report Inappropriate Content
@MaziarR
yeah it is a software glitch for tl-r605. I hope they fix it in their updates whenever that is 
. hello at tplink fix this bug for tl-r605 in latest firmware update maybe add ipv6 feature
thanks!!!
- Copy Link
- Report Inappropriate Content
@langamer101 I agree, where's the IPv6 support?
- Copy Link
- Report Inappropriate Content
@bd1859 it's stated that ipv6 feature will be added in their future firmware updates. so we gotta wait for months
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
The bug has not been fixed yet. Latest firmware for tl-r605 to v1.01 with omada controller 4.2.11.
All of my 7 LAN clients will appear on boot but after 5-10min they disappear forever. Only 3 lan clients will be visible
- Copy Link
- Report Inappropriate Content
here is a video showing over time that the lan clients disappear. also all the lan clients are connected to the switch (t1500g-8t) not the router (tl-r605) but shows on the controller it is connected to the router another bug. after some time it fixes where the lan client is connected to, but most of the lan clients still cannot be seen.
https://youtu.be/IxXvnlhL9vs
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 7114
Replies: 18
Voters 1