My TL-PA8015P KIT is stuck in power saving mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

My TL-PA8015P KIT is stuck in power saving mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Westman49

2021-02-20 14:08:34

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-05-09

My TL-PA8015P KIT is stuck in power saving mode

2021-02-20 14:08:34

Model: Adapter

Hardware Version: V2

Firmware Version:

Hello,

I have a TL-PA8015P KIT. One of them is working normally, but the other one is unable to quit the power saving mode.

It is not recognized by tpCPL.

I tried to pair again the two adapters (1 second press) : fail
I tried to reset the faulty CPL (6 seconds press) : no effect, the LED is always blinking slowly

So I have no network.

Thanks in advance for your help

Best regards

1 Reply

PeterM.

LV2

2021-02-23 09:49:11

Posts: 51

Helpful: 17

Solutions: 3

Stories: 0

Registered: 2020-06-05

Re:My TL-PA8015P KIT is stuck in power saving mode

2021-02-23 09:49:11

@Westman49 For a full factory reset, you'll probably need to hold the button for way longer than six seconds. Just hold it until you see a reaction on the LEDs.

I'd give up after a minute though; next thing to try would then be recovery over LAN.

My TL-PA8015P KIT is stuck in power saving mode

My TL-PA8015P KIT is stuck in power saving mode

Information

Voters 0

Tags