Hi all,

I need to control using SNMP commands à motor drive from my PC. The motor is 192.168.1.100, within the internet router address range.

So I had a R480+ to connect the motor :

Motor  : 192.168.1.100/24   <== NAT ==> 192.168.0.100/24

                                                 | WAN1

                                    <<< R480 >>>>

                                                 | LAN5

                                 PC : 192.168.0.50/24

                                     |

                                   WiFi

                                     |

                                 Internet

I have set up a one-to-one nating connection with theses parameters, but cannot ping or use SNMP between motor and PC (it work with crossover cable and Wifi "unconnected" on PC)

Any ideas ?

Frederic