BUG: Insight->Switch Status reporting incorrect throughput figures

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

BUG: Insight->Switch Status reporting incorrect throughput figures

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
BUG: Insight->Switch Status reporting incorrect throughput figures
BUG: Insight->Switch Status reporting incorrect throughput figures
2022-04-07 23:06:59 - last edited 2022-04-19 09:26:48
Model: SG2008P  
Hardware Version: V1
Firmware Version: 1.0.2

Showing same aggregate figures for UP/DOWN and TX/RX rates.    The latter should be realtime not summation.

 

This is on an OC200 v1.0 5.0.30 sw

<< Paying it forward, one juicy problem at a time... >>
  0      
  0      
#1
Options
1 Accepted Solution
Re:BUG: Insight->Switch Status reporting incorrect throughput figures-Solution
2022-04-19 09:25:56 - last edited 2022-07-25 10:03:28

Dear @d0ugmac1,

 

d0ugmac1 wrote

Showing same aggregate figures for UP/DOWN and TX/RX rates.    The latter should be realtime not summation.

 

This is on an OC200 v1.0 5.0.30 sw

 

Thank you so much for your valuable feedback!

This has been reported to the R&D team for checking, and it's planned to be fixed in the Controller v5.3.

 

I'll actively update this post once there is a new controller version released, welcome to subscribe!

 

Edit: 

OC200 Controller v5.3 has just been released, please take your time for an update.

Omada Hardware Controller V5.3.2 (Released on July 25, 2022)

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:BUG: Insight->Switch Status reporting incorrect throughput figures-Solution
2022-04-19 09:25:56 - last edited 2022-07-25 10:03:28

Dear @d0ugmac1,

 

d0ugmac1 wrote

Showing same aggregate figures for UP/DOWN and TX/RX rates.    The latter should be realtime not summation.

 

This is on an OC200 v1.0 5.0.30 sw

 

Thank you so much for your valuable feedback!

This has been reported to the R&D team for checking, and it's planned to be fixed in the Controller v5.3.

 

I'll actively update this post once there is a new controller version released, welcome to subscribe!

 

Edit: 

OC200 Controller v5.3 has just been released, please take your time for an update.

Omada Hardware Controller V5.3.2 (Released on July 25, 2022)

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:BUG: Insight->Switch Status reporting incorrect throughput figures
2022-07-26 00:55:37

Problem seems to be resolved, thanks for that.  I will monitor over a few more days to ensure stats make sense now.

<< Paying it forward, one juicy problem at a time... >>
  2  
  2  
#3
Options