Switch fail TL-SG1016DE , firmware or hardware?
I recently added a TL-SG1016DE in a client, the configuration it allows is quite basic, but I work with vlans, so it works for me.
my client's network:
*Mikrotik (RB 3011 Router) PORT6 to SW-A (TRUNK)
*Switch A (css326 Mikrotik) "SW-A" PORT 5 to "SW-B" port 16 (TRUNK)
*Switch B (SG1016DE) "SW-A" PORT 16 to "SW-A Port 5" (TRUNK)
Before everything worked correctly, for reasons of 100m or 1000mb it was changed to this switch TL-SD1016DE
I can ensure that the configuration of VLANS and NETWORKS is correct.
--SG1016DE--config--SW-B--
DCHP:disable
Static ip 10.200.255.198
mask 255.255.0.0
Gateway 10.200.0.1
vlan ids (10 - 20 - 30 - 200)
Port 1-4 vlan-id 10
port 5-10 vlan-id 20
Port 11-14 (not used)
Port 15 (EAP245) vlan-id 1 (omada mgnt vlan id 200)
Port 16 TRUNK vlan-id 1
Problem?
when I turn on the switch everything works fine, all devices can access their networks, the node works fine.
After an instant (it can be 10 minutes or 5 hours), I lose the connection of "SG1016DE" "SW-B", the ping does not respond and I cannot access the web to see the configuration. At times it has happened to me that it accesses super slowly to see username and password, but then I click and nothing works.
I sincerely believe that there is no problem in my configuration, it always worked, the cables are ok, I think it is a TPLINK firmware or hardware problem, but TODAY it is the most current firmware that I have to download.
Any ideas? warranty?