NVR keeps rebooting after displaying the cameras on screen

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NVR keeps rebooting after displaying the cameras on screen

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NVR keeps rebooting after displaying the cameras on screen
NVR keeps rebooting after displaying the cameras on screen
2022-12-08 06:26:38
Model: VIGI NVR1016H  
Hardware Version:
Firmware Version:

Hi there, nvr can assign itself an IP address or Auto and connect itself to the internet then able to display the cameras on screen

after a minute the nvr reboots.  The cable is attached to the 16 port POE tplink switch TLSG1218MP i made an update of nvr firmware

tne it still re boots. this re booting does not happen and able to display the cameras in stand alone mode

 

I would tp link technical people or any one who has the same experience

 

any solution thnks

  0      
  0      
#1
Options
1 Reply
Re:NVR keeps rebooting after displaying the cameras on screen
2023-01-10 00:00:57

  @GSUmali 

 

I also got a big problem after the mentioned above update.

 

NVR was in a sort of boot loop, every time it had network connection to the cameras.

After I unpluged network cable, I was able to go into settings and remove all the cameras. After that, NVR also worked with network connected.

As soon as I connected to 1 camera (3rd party, ANPVIZ with 5MP, Dome) NVR gone crazy again.

 

So, I downgraded it to 1.0.1 again, but this should not be the solution.

  1  
  1  
#2
Options

Information

Helpful: 0

Views: 547

Replies: 1