IP Group oddities in Software Controller 5.7.4 (bug?)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IP Group oddities in Software Controller 5.7.4 (bug?)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
IP Group oddities in Software Controller 5.7.4 (bug?)
IP Group oddities in Software Controller 5.7.4 (bug?)
2022-12-16 15:45:33 - last edited 2023-02-09 01:23:07
Hardware Version:
Firmware Version: 5.7.4

Noticed a couple of things in IP Groups (Profiles -> Groups -> Create or Edit) on Omada Software controller v5.7.4.  When adding or editing an IP group from the GUI, the IP address doesn't appear to allow the last octet to be zero.

 

Using the API, it is possible to set a network address with a last octet of zero as expected.  However, there also appears to be a lack of validation in the API which allows setting of an invalid mask for an IP group:

 

The Cloud controller on version 5.6.43 appears to allow zero as the final octet for an IP group as expected; I have not tested the application of an invalid mask against the cloud API.

  2      
  2      
#1
Options
1 Accepted Solution
Re:IP Group oddities in Software Controller 5.7.4 (bug?)-Solution
2023-02-09 01:22:58 - last edited 2023-02-09 01:23:07

Dear @r3naissance,

 

The issue has been fixed in Software Controller v5.8 (the release note doesn't mention it though).

Omada Software Controller_V5.8.4_Linux (Released on Jan 30, 2023)

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  2  
  2  
#3
Options
2 Reply
Re:IP Group oddities in Software Controller 5.7.4 (bug?)
2022-12-16 17:04:37

  @r3naissance 

i noticed the same thing, you can use 10.10.10.1/24 it should give the same result. but there is definitely a bug in the 5.7 controller

 

  0  
  0  
#2
Options
Re:IP Group oddities in Software Controller 5.7.4 (bug?)-Solution
2023-02-09 01:22:58 - last edited 2023-02-09 01:23:07

Dear @r3naissance,

 

The issue has been fixed in Software Controller v5.8 (the release note doesn't mention it though).

Omada Software Controller_V5.8.4_Linux (Released on Jan 30, 2023)

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  2  
  2  
#3
Options

Information

Helpful: 2

Views: 518

Replies: 2

Related Articles