EAP615-Wall(EU) v1.0 and IOT devices
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.EAP615-Wall(EU) v1.0 and IOT devices
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi All
I am trying to setup some IOT devices(TX Series of Sonoff)
I have setup a 2.4 GHz network on the EAP615 and a different 2.4Ghz on EAP235.
The IOT device connects and works fine with the EAP235 SSID but does not want to work correctly on the EAP615 2.4GHz SSID.
Any advice on what I am doing wrong or what I can change to make it work?
I am using the Omada controller software to manage the devices. I have tried with different EAP615 devices.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Coenie you are using a EU access point, which has and additional channel on 2.4 while the sonoff device might not be compatible, be sure you use 1 or 11 only if you are using 40 MHz.
- Copy Link
- Report Inappropriate Content
Hi, thank for the reply, i tried this setting on channel 1...13 and not one of them allowed the stupid iot device to connect. perhaps i changed the wrong setting ?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, this was one of my first things i tried, I used extender to create new SID and the sonoff device connected and worked correctly, i then shut downed the extender and rename the SID on the Omada, the sonoff device just does not want to connect to the SID on the omada AP. But I will try this again. I just think that the LED strip is really just very picky about the wifi standard, the other sonoff devices can connect correctly. Just these strips are a pain .
- Copy Link
- Report Inappropriate Content
I found this in my log file on the omada controller, perhaps this could help somebody
[Failed] xx-xx-xx-xx-xx-xx failed to connected to xx-xx-xx-xx-xx-xx with SSID "iot" on channel 10 because WPA Authentication times out/failed.(5 times in a minute)
- Copy Link
- Report Inappropriate Content
@Coenie alguém tem algum alternativa estou com o mesmo problema.
- Copy Link
- Report Inappropriate Content
@Jcbolive At end I had to get older omada device to make the connection. I am not sure what the issue is with the new AP points
The "older" one that made it work for me.
https://www.tp-link.com/za/business-networking/omada-sdn-access-point/eap115-wall/
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2416
Replies: 18
Voters 0
No one has voted for it yet.