Business Community > WiFi > TP-Link passive POE adapter not working
< WiFi

TP-Link passive POE adapter not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP-Link passive POE adapter not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link passive POE adapter not working
TP-Link passive POE adapter not working
2023-02-07 11:01:00 - last edited 2023-02-09 11:39:57
Tags: #Installation #poe
Model: EAP110-Outdoor  
Hardware Version: V3
Firmware Version:

Soooo I recently purchased a new TP-Link EAP110 for my house for faster WiFi even if I have Google WiFi (it gets really slow when i'm in the bedroom). And I went ahead and did all the instructions but when I plugged in the POE adapter, it was immediately solid green. The manual said it has to flash first and then it will turn green. 

It won't show in my WiFi Networks list too.

Please help!

 

Thank you in advance.

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:TP-Link passive POE adapter not working-Solution
2023-02-08 11:55:09 - last edited 2023-02-08 13:23:26

  @Hank21 I already fixed it. I used a yellow Ethernet cable. Thanks anyways!

 

 

 

Recommended Solution
  2  
  2  
#4
Options
3 Reply
Re:TP-Link passive POE adapter not working
2023-02-07 13:46:28

  @ducky328 

 

Simple case of RTFM (which can be found https://static.tp-link.com/upload/manual/2022/202209/20220924/7106509808-EAP225-Outdoor_IG.pdf)

 

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#2
Options
Re:TP-Link passive POE adapter not working
2023-02-08 07:43:00

Dear  @ducky328 

 

Have you tried a different Ethernet cable between your EAP and the PoE injector? 

 

Please also try to reset the EAP via pushing RESET hole for 10 seconds.

 

If you still cannot see the default SSID, please check warranty service with local support.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#3
Options
Re:TP-Link passive POE adapter not working-Solution
2023-02-08 11:55:09 - last edited 2023-02-08 13:23:26

  @Hank21 I already fixed it. I used a yellow Ethernet cable. Thanks anyways!

 

 

 

Recommended Solution
  2  
  2  
#4
Options

Information

Helpful: 0

Views: 540

Replies: 3

Tags

Installation
poe
Related Articles
TP-Link EAP225: can it be used without the passive POE adapter?
691 0
Can I use EAP 235 wall with passive poe adapter?
991 0
In the Passive Adapter (EAP-110), can I put the LAN port to the PoE Switch (1-4 port)???
827 0
Common Questions About TP-Link EAP Device When It's Used in Home Network
11518 0
About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.