Routed Port Keeps Disabling DHCP Filter Globally After Interface Goes Down and UP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Routed Port Keeps Disabling DHCP Filter Globally After Interface Goes Down and UP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Routed Port Keeps Disabling DHCP Filter Globally After Interface Goes Down and UP
Routed Port Keeps Disabling DHCP Filter Globally After Interface Goes Down and UP
2023-02-07 22:30:32 - last edited 2023-02-07 22:47:12
Model: TL-SG3428  
Hardware Version: V2
Firmware Version: 2.0.9 Build 20221021 Rel.62172

Hi,so as part of doing inter vlan routing, i have setup interface gigabitethernet 1/0/2 as a routed port and setup a default route using my routers interface ip address as the next hop for 0.0.0.0/0 ,etc.  My g1/0/2 interface keeps going down, almost daily. i have the routed port connected to the lan port on my pfsense router and somehow when i lose internet connection (which is normal for me...) the routed port seems to also go down and disable a bunch of stuff on vlan1000, its internal vlan, but also disables dhcp filter globally which is very annoying.

 

I get that dhcp filter is a layer 2 security and this switch is basically "emulating" a layer 3 interface *cuz its using internal vlans* by using the no switchport command and disabling some layer 2 protocols, but is there no way to not have it disable dhcp filter globally? its not even enabled on that port...

 

here are the logs that i get almost daily:

 

63

2023-02-07 13:31:32
    
Link Scan
    
level_5
    
  Gi1/0/2 changed state to up.
64    
2023-02-07 13:30:56
    
NETIF
    
level_5
    
  Line protocol on Interface Gi1/0/2, changed state to down.
65    
2023-02-07 13:30:56
    
NDSnoop
    
level_6
    
  Disable ND Snooping function in vlan 1000.
66    
2023-02-07 13:30:56
    
DHCP6Snoop
    
level_6
    
  Disable DHCPv6 Snooping function in vlan 1000.
67    
2023-02-07 13:30:56
    
NDDetec
    
level_6
    
  Disable ND Detection function in vlan 1000.
68    
2023-02-07 13:30:56
    
DHCPF
    
level_6
    
  Disable DHCP Filter successfully.
69    
2023-02-07 13:30:56
    
DHCPL2R
    
level_6
    
  Disable DHCP L2 Relay function in vlan 1000.
70    
2023-02-07 13:30:56
    
DHCP Snooping
    
level_6
    
  Disable DHCP Snooping function in vlan 1000.
71    
2023-02-07 13:30:56
    
ARP&IP
    
level_6
    
  Disable ARP Inspection in VLAN 1000.
72    
2023-02-07 13:30:56
    
FDB
    
level_6
    
  Deleted all Mac address associated with VLAN 1000.
73    
2023-02-07 13:30:56
    
Link Scan
    
level_5
    
  Gi1/0/2 changed state to down.

  0      
  0      
#1
Options
1 Reply
Re:Routed Port Keeps Disabling DHCP Filter Globally After Interface Goes Down and UP
2023-02-08 03:07:46

Dear @PWN,

 

Our engineer may need your configuration file to check the issue. To better assist you, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. The ticket ID is TKID230213141, please check your email box and ensure the support email is well received. Thanks!

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 269

Replies: 1