Home

Forums

Stories

Knowledge Base

Business Community > WiFi > 5Ghz Band Steering on EAP245 V3 with OC200 Omada controller

< WiFi

5Ghz Band Steering on EAP245 V3 with OC200 Omada controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

5Ghz Band Steering on EAP245 V3 with OC200 Omada controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NoebiWan

2023-02-20 11:50:18

Posts: 5

Helpful: 3

Solutions: 0

Stories: 0

Registered: 2023-02-02

5Ghz Band Steering on EAP245 V3 with OC200 Omada controller

2023-02-20 11:50:18

Tags: #EAP ACL

Model: EAP245

Hardware Version: V3

Firmware Version:

Hi All,

After help with this forum on finding out how to enable Bandsteering on OC200 with EAP245 v3, i run now into the followin issue.

Although bandsteering is set to 5ghz priority, still my samsung S21 FE is connected to the 2.4Ghz band.

The only way to connect to 5Ghz is to turn off wifi on the phone and that turn it on again. Also this does not help always, as the phone reconnects to 2.4Ghz sometimes.

The other possibility i checked was to use the "reconnect" possibility in the Omada controller.

My question is; is there a way to "Force" the controller to have the phones connected to 5ghz ?

Thanks for the support

1 Reply

Philbert

LV5

2023-02-20 22:55:16

Posts: 2607

Helpful: 1544

Solutions: 273

Stories: 0

Registered: 2020-11-08

Re:5Ghz Band Steering on EAP245 V3 with OC200 Omada controller

2023-02-20 22:55:16

@NoebiWan

Hey

There is no way to force the device to move to the other frequency every time

I have found some mobile devices stick to the 2.4ghz when its in low usage / sorta idle as the power required is lower on 2.4 vs 5ghz which will obviously be better for battery. They tend to ramp up / switch when you start to push the device a bit harder and more WAN traffic is required.

Sadly this is not an exact science. The AP can only make available 5ghz, however if the device doesn't probe (ask) for a 5ghz connection the AP cant move it across.

5Ghz Band Steering on EAP245 V3 with OC200 Omada controller

5Ghz Band Steering on EAP245 V3 with OC200 Omada controller

Information

Voters 0

Tags