Best setup of Advanced Features
Experts out there, you may want to share your knowledge what is the best setup of this Advance features.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
You are not far off the best setup, enable band steering and set for Prefere 5ghz/6hghz.
Fast Roaming is just roaming.. leave it enabled
AI Roaming is letting the controller move you early / proactively as it feels appropiate to load balance, pre-empt a roam etc.. it works well leave it enabled.
Dual Band.. only enable this is you use Band Steering (recommended). This basically means you can roam from a 2.4 connection on AP1 to a 5ghz connection on AP2 in one move, doesnt make much difference.. but its a tad quicker
Force Disconnect.. enable but its likely never used. Basically if you have an older devices (very old) that doesnt support roaming, if asked to roam and doesnt respond the controller will kill the connection and force it to roam that way.. rarely if ever see this happen tbh.
As said, band steering is a good idea, works well!
- Copy Link
- Report Inappropriate Content
@Ric04jan72 I would not blindly trust that features are working as expected. By all means try them but also monitor what is going on. I figured out a while back that with Fast Roaming and disassociation enabled I had very poor results. For the sake of this post I re-enabled those settings and let them ride for about an hour. Almost immediately I had 6 clients in <-72 range, when before I had 100% RSSI. Within half an hour we had clients contacting the office and complaining of poor performance and even the lack of ability to connect.
This is just a few minutes after reverting back to my settings with only Band Steering enabled. I am not saying those settings don't work, just saying they have not worked in my scenario and if you're going to try them, monitor the results.
- Copy Link
- Report Inappropriate Content
@RickJamesBish @Philbert
Thank you for sharing your knowledge and expertise.
I will change my setup based on your recommendations.
- Copy Link
- Report Inappropriate Content
@Ric04jan72 As a user of the OC200 with the hardware version V2 and firmware version 2.7.7 Build 20221206 Rel.58608, I would love to hear from experts about the Best setup for its advanced features. Any insights or recommendations would be greatly appreciated!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 718
Replies: 4
Voters 0
No one has voted for it yet.