Omada AP keeps disconnecting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada AP keeps disconnecting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada AP keeps disconnecting
Omada AP keeps disconnecting
2023-09-30 23:08:21 - last edited 2023-10-18 06:55:21
Model: EAP650-Outdoor  
Hardware Version: V1
Firmware Version: 1.0.4 Build 20230421 Rel. 76150

Hello,

My config is as follows:

 

OC200

TL-SG3428MP v5.0 ( 5.0.6 Build 20230602 Rel.76586 )

ER7206 v1.0 ( 1.3.0 Build 20230322 Rel.70951 )

3x EAP660 HD(US) v1.0 ( 1.1.1 Build 20220118 Rel. 60852 )

1x EAP650-Outdoor(US) v1.0 ( 1.0.4 Build 20230421 Rel. 76150 ) which keeps disconnecting.


From time to time mentioned AP disconnects, I tested the cable it seems all good. It is connected via a POE port. Sometimes I can bring it back by doing "POE recovery" from config and sometimes not. Sometimes I can get it back by rebooting the switch.

Can somebody help with advice and a solution, it is getting annoying

 

Thanks in advance

Ivan

 

Screenshot

  1      
  1      
#1
Options
1 Accepted Solution
Re:Omada AP keeps disconnecting-Solution
2023-10-13 20:18:35 - last edited 2023-10-16 00:55:09

  @Loop1 Just to report. The cable was not good (connector was bad) All good now. Thanks for help

Recommended Solution
  2  
  2  
#4
Options
3 Reply
Re:Omada AP keeps disconnecting
2023-10-01 03:09:49

  @Loop1 

 

Temporarily bring the AP indoor and connect it directly to the 3428P with a known good short cable.  Does the problem continue to happen?  My expectation is that disconnects cease happening, meaning your cabling or connectoring has issues.

<< Paying it forward, one juicy problem at a time... >>
  1  
  1  
#2
Options
Re:Omada AP keeps disconnecting
2023-10-01 06:20:39

  @d0ugmac1 Thanks for answer, will try today and report it

  0  
  0  
#3
Options
Re:Omada AP keeps disconnecting-Solution
2023-10-13 20:18:35 - last edited 2023-10-16 00:55:09

  @Loop1 Just to report. The cable was not good (connector was bad) All good now. Thanks for help

Recommended Solution
  2  
  2  
#4
Options