CPE210 How to configure?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE210 How to configure?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE210 How to configure?
CPE210 How to configure?
2023-12-22 09:15:17
Model: CPE210  
Hardware Version: V3
Firmware Version: 2.2.6 Build 20230907 Rel. 39920 (4555)

Hello everyone, I'm trying to explain the situation. I have two houses close to each other, approximately 20 meters apart. In house A, I have a router connected to the internet with the IP address 192.168.1.1. In house B, I have a network with several devices connected to a switch, and I would like this network to have the IP address 192.168.2.X to keep them separate. In house B, there is no internet, and I bought the CPE210 product to connect house B to house A.

Could you please help me understand which mode to use and how to configure it? In my house, I have a Cisco access point and a switch, and I believe the CPE should also act as a DHCP server. I also have an old router with DDWRT installed on it in case it could be useful. Thank you.

  0      
  0      
#1
Options
1 Reply
Re:CPE210 How to configure?
2023-12-25 07:15:19

  @Joesatriani 

 

If you set CPE with WISP mode, it will be used as the DHCP Server, take a look:

6. AP Client Router (WISP Client)

Just striving to develop myself while helping others.
  0  
  0  
#2
Options