Business Community > Switches > Auto MDI-X recognition Omada controller
< Switches

Auto MDI-X recognition Omada controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Auto MDI-X recognition Omada controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Auto MDI-X recognition Omada controller
Auto MDI-X recognition Omada controller
2024-01-09 10:51:04 - last edited 2024-01-26 02:44:48
Model: TL-SG2428P  
Hardware Version: V4
Firmware Version: 4.0.6 Build 20230602 Rel.73473

Hi,

I have a few network ports which are wired the wrong way on one side.
One end is TIA-568A and the other end is TIA-568B. 
 

The TL-SG2428P v4.0 is recognizing this via MDI-X and is fixing it internaly.


I like to fix these ports physicaly to avoid problems in the future but I'm not shure which port are affected.


Is there any chance to find these ports in the omada controller or somehow else?

 

best regards


Sven

  0      
 
  0      
 
#1
Options
2 Accepted Solutions
Re:Auto MDI-X recognition Omada controller-Solution
2024-01-12 07:44:13 - last edited 2024-01-26 02:44:48

Hi @Scorven 

Thanks for posting in our business forum.

Hmm if it is in controller mode, it does not have any feature to detect the cable.

If in standalone, you might check this.

 

Recommended Solution
  2  
  2  
#2
Options
Re:Auto MDI-X recognition Omada controller-Solution
2024-01-26 02:44:37 - last edited 2024-01-26 02:44:50

Hi @Scorven 

Thanks for posting in our business forum.

Scorven wrote

Hi and thanks for the answer. Can I switch from controller mode in standalone and back without any issues?

Switch from any mode to another will lose the config. Please make sure you back them up.

 

Sorry for the late rely, please make sure you @ me when you reply. Or click reply under my post so I can be mentioned.

 

Recommended Solution
  1  
  1  
#4
Options
3 Reply
Re:Auto MDI-X recognition Omada controller-Solution
2024-01-12 07:44:13 - last edited 2024-01-26 02:44:48

Hi @Scorven 

Thanks for posting in our business forum.

Hmm if it is in controller mode, it does not have any feature to detect the cable.

If in standalone, you might check this.

 

Recommended Solution
  2  
  2  
#2
Options
Re:Auto MDI-X recognition Omada controller
2024-01-15 09:53:21
Hi and thanks for the answer. Can I switch from controller mode in standalone and back without any issues?
  0  
  0  
#3
Options
Re:Auto MDI-X recognition Omada controller-Solution
2024-01-26 02:44:37 - last edited 2024-01-26 02:44:50

Hi @Scorven 

Thanks for posting in our business forum.

Scorven wrote

Hi and thanks for the answer. Can I switch from controller mode in standalone and back without any issues?

Switch from any mode to another will lose the config. Please make sure you back them up.

 

Sorry for the late rely, please make sure you @ me when you reply. Or click reply under my post so I can be mentioned.

 

Recommended Solution
  1  
  1  
#4
Options

Information

Helpful: 0

Views: 683

Replies: 3

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.