Future Consideration ER707-M2 PPPoE Static IP secondary connection issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
My ISP provide 10 static IP over PPPoE connection. I try to setup connection with fixed IP provide by ISP but seems failed. In order to work i need to use PPPoE to dial the connection. However, when i try to add for the secondary connetion IP is getting failed to get connect.
Since i got 10 static IP, how can i configure to use my static IP as when trying to configure NAT it doesn't work on PPPoE connection.
1. NAT one to one is only work on WAN Static IP and but not with PPPoE.
2. I've enable policy routing for source and destination any to any via WAN it also failed to get route.
refer with the logs
MGS-Greek wrote
Hi,
My ISP provide 10 static IP over PPPoE connection. I try to setup connection with fixed IP provide by ISP but seems failed. In order to work i need to use PPPoE to dial the connection. However, when i try to add for the secondary connetion IP is getting failed to get connect.
Since i got 10 static IP, how can i configure to use my static IP as when trying to configure NAT it doesn't work on PPPoE connection.
1. NAT one to one is only work on WAN Static IP and but not with PPPoE.
2. I've enable policy routing for source and destination any to any via WAN it also failed to get route.
MGS-Greek wrote
Hi,
My ISP provide 10 static IP over PPPoE connection. I try to setup connection with fixed IP provide by ISP but seems failed. In order to work i need to use PPPoE to dial the connection. However, when i try to add for the secondary connetion IP is getting failed to get connect.
Since i got 10 static IP, how can i configure to use my static IP as when trying to configure NAT it doesn't work on PPPoE connection.
1. NAT one to one is only work on WAN Static IP and but not with PPPoE.
2. I've enable policy routing for source and destination any to any via WAN it also failed to get route.
