VLAN set-up
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi all,
I have:
- TL-SG3428 V2.0 firmware: 2.0.11 Build 20230602
- TL-SX3008F V1.0 firmware 1.20.0 Build 20231011
- Both PC have 2 NICs
Basically what I wish to archive is:
- VLAN for managment
- VLAN for enddevices
- Other VLAN
The problem is that I can't recive a DHCP form my router for the VLAN30. Also if I assing a static IP at PC-A or PC-B I can't connect to the internet.
There are no missconfig in router side couse if I delete the trunk between the 2 swithces and I assing only VLAN30 everyting works
Hope some of you could help me,
Thanks in advance
It seems like that your suggestion does work!
Port 2/3 are for PCA & PCB port 23 is the router port 28 is the uplink to the second switch
For PVID nothing change from my last post
The second switch is configure as below
PC A&B are on port 2-3 the trunk is on port 8
Thank you so much!
It seems like that your suggestion does work!
Port 2/3 are for PCA & PCB port 23 is the router port 28 is the uplink to the second switch
For PVID nothing change from my last post
The second switch is configure as below
PC A&B are on port 2-3 the trunk is on port 8
Thank you so much!