ER706w-4G doesn't reconnect back to main wan automatically after dropout to backup
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi
i've been having constant issues with the failover where once it fails over to the backup in this case 4g it stays on 4g permanently and doesn't auto connect back to the main wan.
I've noticed that for some reason it's constantly dropping off main wan but not sure if it's the router or the internet connection irrespective it should revert back to main wan.
Load Balancing is ticked.
Link Backup is set :
- WAN2 Primary WAN
- Backup WAN LTE
- Mode: Backup when all primary WANs fail.
it fails over to LTE no problem but never switches back. i've left it running over night.
any help appreciated.
Hi @locn
Thanks for posting in our business forum.
Make sure you have properly configured it.
If you are certain that you have configured it correctly, show me the screenshot of your config as well as your test methodology.
If you have any questions, the above KB should resolve all of them about the load balancing.
i think it's all correct.
let me know if you need any thing else?
when it drops out wan2 goes "offline" but then the only way to reconnect it is i have to go into the "network" -> "wan2" the manually hit "connect"
strange thing is even when it says "offline" in the "online detection" under "network" -> "wan2" it'll say connected with the IP address.
Hi @locn
Thanks for posting in our business forum.
OK. I see. You should try the controller mode where you have the option to "always link primary". Adopting the controller would erase your settings. Please be aware of this. Config from standalone does not work on the controller.
