Hi @Peterdevon 

Thanks for posting in our business forum.

Hmm. They don't correlate. Do you have a v6 address or not?

Run the basic command and display the v6 address.

The ACL is correct because if you need Internet v6 to access the local devices.

Please mosaic your sensitive information. Here is a list of information considered sensitive:

1. Public IP address on your WAN if your WAN is.

2. Real MAC address of your device.

3. Your personal information including address, domain name, and credentials.

For troubleshooting purposes, when a WAN IP is needed, please leave some values visible for identification.

  @Clive_A 

I have an IP address and so do the clients

Hi @Peterdevon 

Thanks for posting in our business forum.

Peterdevon wrote

  @Clive_A 

 

 

 

I have an IP address and so do the clients

 

 

 

 

What's the v6 IP you have on the clients?

Is that FE80::? That's not a public v6 address but a link local.

If you need that direct access from the Internet, you should get a 2A0C:: on the local devices.

  @Peterdevon 

The IP address starts 2a0c:4f42 and the clients are getting one with the same prefix with a number at the end

Thanks

Hi @Peterdevon 

Thank you so much for taking the time to post the issue on TP-Link community!

To better assist you, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. The ticket ID is TKID240650678, please check your email box and ensure the support email is well received. Thanks!

Once the issue is addressed or resolved, welcome to update this topic thread with your solution to help others who may encounter the same issue as you did.

Many thanks for your great cooperation and patience!

Hi @Peterdevon 

What would be your firmware version? 1.4 is not an accurate firmware version.