Hi,

I just received my EAP772 access point. First I had some trouble getting it adopted but after a factory reset it worked fine.

However, even under very light load (4 - 5 clients) it gets extremely hot. Not sure if related to the temperature but it also started re-adopting in my controller several times yesterday. I didn't want to leave it running overnight because of the heat, I hooked it up about 2 hours ago and so far it seems to be running without readopting (but that also happened after a few hours yesterday). The temperature seems to be quite high again however.

Anyone else have the same experience with this type of access point? 

Kind regards

Wesley