VPN IPSec Failover
Hi, is there a way to configure the VPN IPSec Failover for Omada GUI ?
https://www.tp-link.com/us/support/faq/3575/ this is for standalone mode and i cannot get to work with my setup.
i have both site with both two active wan, my current setup is site-to-site with Manual IPsec and with multple subnets.
If i change this to Auto IPSec could i get what i am looking for?
It is getting a little bit of annoying switching manually.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Jeesoon1
Thanks for posting in our business forum.
Proceed with the manual creation of the tunnel and follow the guide standalone. The parameters should be matched in two tunnels. Then you go back to the page and choose them.
- Copy Link
- Report Inappropriate Content
Hi @Jeesoon1
Thanks for posting in our business forum.
Proceed with the manual creation of the tunnel and follow the guide standalone. The parameters should be matched in two tunnels. Then you go back to the page and choose them.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, unfortunately as per the guide the policy should use the IKEv1 which a single subnet only.
This is the warning when adding a either remote subnet or local networks
- Copy Link
- Report Inappropriate Content
Hi @Jeesoon1
Thanks for posting in our business forum.
Jeesoon1 wrote
Hi, unfortunately as per the guide the policy should use the IKEv1 which a single subnet only.
This is the warning when adding a either remote subnet or local networks
Then use IKEv2. The guide did not use it because it does not require more than one subnet.
In different situation, play differently. The baseline is still the guide.
- Copy Link
- Report Inappropriate Content
Thanks! that works.
How about if i have both 2 ISP per site? what should be the best approach for this vpn ipsec fail-over ?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 483
Replies: 6
Voters 0
No one has voted for it yet.