Omada Software Controller Incomplete Network topology

Omada Software Controller Incomplete Network topology

Omada Software Controller Incomplete Network topology
Omada Software Controller Incomplete Network topology
3 weeks ago - last edited 3 weeks ago
Tags: #Controller Installation #network topology
Hardware Version:
Firmware Version: 5.14.26.1

Hello, i switched everything over to tp-link and the actual topology is below but the network topology with in the controller is only showing the ER605. I tried restarting all equipment including the controller, deleted browser cache, force provision all devices from controller and even controller migration. please advise.

 

ER 605 (LLDP enabled)

             >> TL-SG1005P >> EAP610 && EAP615-Wall
             >> TL-SG2008   >> EAP610 

 

 

 

when the ER 605 is removed this is what i see (missing the two EAPs that are connected to SG1005P

 

  0      
  0      
#1
Options
4 Reply
Re:Omada Software Controller Incomplete Network topology
3 weeks ago

Hi  @SivaM 

 

Did you try rebooting the whole system? Including the router, switches, EAPs, and the controller?

Better to boot them up in this order: Router>Controller>Switches>EAPs.

  0  
  0  
#2
Options
Re:Omada Software Controller Incomplete Network topology
3 weeks ago

Hi @Vincent-TP, tried the reboot again with the exact order you recommended and still no luck. any other suggestions? 

 

 

  0  
  0  
#3
Options
Re:Omada Software Controller Incomplete Network topology
3 weeks ago - last edited 3 weeks ago

when i remove the router, i see the switch and 1 EAP but no the other 2 where are connected to TL-SG1005P >> EAP610 && EAP615-Wall

 

 

 

  0  
  0  
#4
Options
Re:Omada Software Controller Incomplete Network topology
3 weeks ago

Hi  @SivaM 

 

Is this option enabled?

 

What if remove the switch TL-SG1005P?

  0  
  0  
#5
Options