ER605 VPN Server issue
ER605 VPN Server issue
Hi everyone,
I just upgraded my ER605 firmware from 2.0.0 to 2.2.4, and my OpenVPN setup doesn't work anymore.
The ER605 is behind a modem (on the NAT port) on which dynamic DNS is set up.
I have also setup a dynamic dns on the ER605 as well (the same as the modem).
However, after the firmware upgrade, my VPN stopped working, and I can only connect now via remote IP and not the DNS name which is not ideal as my IP is dynamic.
Here is the OpenVPN setup as well:
After I downloaded the OpenVPN config file I changed the IP to reflect the DNS name
As mentioned, I've tried deleting old entries and making new ones without any success (at this point, I'm not sure if I've messed up anything after so many tries).
The same setup used to work before the firmware upgrade.
Any ideas about what I can do or where to look for a solution ?
Thanks!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@MR.S
@Clive_A
I've tried both ways with comp-lzo adaptive and comp-lzo without any success, unfortunately. My OpenVPN Connect client is v3.5
- Copy Link
- Report Inappropriate Content
I've tried everything I could think of.
Resetting the router and configuring it from the beginning,
Creating a new DDNS domain,
Downgrade the firmware to v2.0.0 where it used to work (it did not work this time).
I don't know what else to try now, and I'm not even sure where the problem is. The only thing I'm sure of is that I regret upgrading the firmware in the first place.
Jokes apart, this is a huge problem for me as this setup serves my office lab for remote access as I'm rarely at this office and I need to access the server daily.
- Copy Link
- Report Inappropriate Content
try downgrading the OpenVPN connect client to 3.4.4 you can also try the tp-link client
https://www.tp-link.com/en/support/download/er605/v2/#VPN_Client
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
There must be a misconfiguration somewhere. try setting the ip pool to 10.22.1.1/24, I don't have any problems, I've tested several vpn clients and they all work.
Have you configured any router ACLs?
- Copy Link
- Report Inappropriate Content
Hi @jpmaglees
What's your WAN like? Like the first DDNS result? Does the VPN even connect?
- Copy Link
- Report Inappropriate Content
My WAN is nothing special. The only thing connected to my ISP's modem is the ER605.
So, the network architecture goes like this:
1) The ISP's modem with DDNS setup and port forwarding the OpenVPN port to my ER605
2) From Modem LAN to ER605 WAN
3) The ER605 as an OpenVPN server with the same DDNS setup as the modem.
That's it, after that, some devices are connected to ER605 LAN ports.
The first DDNS cannot be resolved remotely, but that's normal, I believe, as the ISP is blocking ICMP. However, you can NMAP the DDNS.
OpenVPN only connects via the WAN IP from ER605, but of course, I have to be on the network for that.
What bothers me is how the firmware upgrade affects the OpenVPN setup, which was working previously with no problems.
The only thing remaining to try is to reset both the ISP's modem and ER605 and try again.
Nothing else comes to my mind.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 580
Replies: 11
Voters 0
No one has voted for it yet.