Business Community > Gateways > Wireguard - under the covers
< Gateways

Wireguard - under the covers

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wireguard - under the covers

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wireguard - under the covers
Wireguard - under the covers
2024-10-30 13:57:26 - last edited 2024-11-01 01:13:01
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.2.6 Build 20240718 Rel.82712

I'm trying to understand how the SDN (OC200 Firmware Version = v2.16.3 Build 20240620 Rel.81038 and SDN v5.14.26.23) configures Wireguard.

 

I am interested to see if Masquerading is turned 'on' or 'off' and if it is possible to switch this setting?

 

I am assuming MSS Clamping is 'off' and that possibly there is a 'hidden' firewall zone for wireguard that dictates input, output and forward settings.

 

Regards,

 

Mike

 

 

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Wireguard - under the covers-Solution
2024-10-31 10:42:25 - last edited 2024-11-01 01:13:01

  @Clive_A Hi Clive,

 

I've now set my Wireguard Peer allowed IP's to:

 

0.0.0.0/1

128.0.0.0/1

::/1

8000::/1

 

Many thanks for your guidance.

 

Mike

Recommended Solution
  1  
  1  
#3
Options
3 Reply
Re:Wireguard - under the covers
2024-10-31 01:58:55 - last edited 2024-10-31 01:59:28

Hi @mortimm 

Thanks for posting in our business forum.

It depends on how you configure your routing in peer settings.

Masking Your IP Address: Setting Up a Full Tunnel VPN Connection (PPTP/L2TP/OpenVPN/WireGuard)

 

We encourage you to search and use the label and tag to find out the existing guides we have.

  3  
  3  
#2
Options
Re:Wireguard - under the covers-Solution
2024-10-31 10:42:25 - last edited 2024-11-01 01:13:01

  @Clive_A Hi Clive,

 

I've now set my Wireguard Peer allowed IP's to:

 

0.0.0.0/1

128.0.0.0/1

::/1

8000::/1

 

Many thanks for your guidance.

 

Mike

Recommended Solution
  1  
  1  
#3
Options
Re:Wireguard - under the covers
2024-11-01 01:14:15

Hi @mortimm 

Thanks for posting in our business forum.

mortimm wrote

  @Clive_A Hi Clive,

 

I've now set my Wireguard Peer allowed IP's to:

 

0.0.0.0/1

128.0.0.0/1

::/1

8000::/1

 

Many thanks for your guidance.

 

Mike

As we don't support v6 yet, setting v6 addresses here does not hurt a thing. But if you run into trouble when you access IPv6, remove them.

  1  
  1  
#4
Options

Information

Helpful: 0

Views: 390

Replies: 3

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.