Background:

 

This post provides a guide on how to make the VPN client connect to the VPN server to mask the real IP address (full tunnel). Or use the remote proxy gateway to access the Internet.

 

This Article Applies to:

 

All routers with the supported VPN types.

 

 

1. PPTP/L2TP VPN

 

Go to Control Panel > Network and Internet > Network and Sharing Center > Change Adapter Settings, then you will find the PPTP/L2TP VPN adapters.

Right-click the adapter > Properties > Networking, double-click Internet Protocol Version 4 > Advanced, and then you will find the Advanced TCP/IP settings for the VPN.

 

 

2. OpenVPN

 

While you export the file from the OVPN server, please make sure you have chosen Full Tunnel.

You are not allowed to change the access type on the client software.

 

 

3. WireGuard VPN

 

Go to the WireGuard client settings, and set up the AllowedIPs as 0.0.0.0/0.

 

 

Update Log:

 

Jul 26th, 2024:

Release of the article.

 

Recommended Threads:

 

How to establish an L2TP Server by Omada Gateway in Standalone mode

How to Configure WireGuard VPN on Omada Controller

What to do if you cannot access the remote network through Client-to-LAN/Site VPN tunnel

 

Feedback:

 

• If this was helpful, welcome to give us Kudos by clicking the upward triangle below.
• If there is anything unclear in this solution post, please feel free to comment below.

 

Thank you in advance for your valuable feedback!

 

------------------------------------------------------------------------------------------------

Have other off-topic issues to report? 

Welcome to > Start a New Thread < and elaborate on the issue for assistance.