OC200, after adopting ER605 the internet access stopped.
I have an ER605 already configured, I implemented a new OC200, after adopting it, internet access stopped, the ports appear offline.
I had to reset the ER605 and go back to using only the ER605
ER605 v2.0 - 2.2.5 Build 20240522 Rel.75860
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
When adopt the router on the OC200, it will apply OC200's Internet config. And the default Internet connection type is Dynamic IP.
What's the Internet connection type of your network?
You should first go to the following page to configure the Internet connection type:
- Copy Link
- Report Inappropriate Content
When adopt the router on the OC200, it will apply OC200's Internet config. And the default Internet connection type is Dynamic IP.
What's the Internet connection type of your network?
You should first go to the following page to configure the Internet connection type:
- Copy Link
- Report Inappropriate Content
Vicente, Thank you for your support and attention.
I checked this configuration was correct.
I have two internet links:
WAN1 PPPoE
WAN2 Static IP
Is it necessary to create an outbound ACL?
When I return to this client I will review it again.
Can you tell me if there is a VPN on this router, does the controller have the settings?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 103
Replies: 2
Voters 0
No one has voted for it yet.