ER605 V2 as client, does not work with OpenVPN client-to-site
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have configured a couple of VLAN to go through a client-to-site OpenVPN setup and it is working great.
But as soon as I tried doing the same for a second OpenVPN for a different VLAN/Interfaces, it does not work.
If I disable all the OpenVPN clien-to-site, and then reenable them in different order, it is always the first one that was enabled that works correctly, the other vlan does not have any internet.
I have the same issue as this thread: https://community.tp-link.com/en/home/forum/topic/609790
@MR.S You are right! I don't know why, but I was under the impression I could set source vlan (from my network), to each use and redirect all traffic. My goal was to "connect" different VLAN with different cloud Server/IPs, so that each VLAN would have different public IPs, but it seems I was wrong.
Removing the default route push through every VPN server I had fixed it.
I still have to rethink/redesign what I want to accomplish though 
Thanks.
@Clive_A I am back from the Holidays, sorry for the delay.
I am trying to use multiple Client-to-Site VPN OpenVPN(Client)
The only Client-To-Site VPN that is redirecting the traffic correctly is the first one(order) I enable. I Can disable all of them, and then renable the third one in the list first, and then enable the others, only the first that was enabled is working.
@MR.S You are right! I don't know why, but I was under the impression I could set source vlan (from my network), to each use and redirect all traffic. My goal was to "connect" different VLAN with different cloud Server/IPs, so that each VLAN would have different public IPs, but it seems I was wrong.
Removing the default route push through every VPN server I had fixed it.
I still have to rethink/redesign what I want to accomplish though
Thanks.