Business Community > Gateways > failsafe VPN client to block traffic when disconnect detected.
< Gateways

failsafe VPN client to block traffic when disconnect detected.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

failsafe VPN client to block traffic when disconnect detected.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
failsafe VPN client to block traffic when disconnect detected.
failsafe VPN client to block traffic when disconnect detected.
2025-05-13 13:19:02 - last edited 2025-05-14 01:55:05
Tags: #VPN
Model: ER8411  
Hardware Version: V1
Firmware Version: 1.2.3

I am not sure if this is a configuration with Omada or within ER8411.  But I need to set up a failsafe to stop traffic going out of the VPN CLient.  Is there a guide for that?  Because I don't see anything within the omada's VPN.  I figure it must be done elsewhere.

  0      
 
  0      
 
#1
Options
1 Reply
Re:failsafe VPN client to block traffic when disconnect detected.
2025-05-14 02:54:47

Hi @mbze430 

Thanks for posting in our business forum.

You mean kill switch when the router is the VPN client? That function is not available. Don't support it yet.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 342

Replies: 1

Tags

VPN
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.