Home Network Community > Deco > Dec P9 configuration
< Deco

Dec P9 configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Dec P9 configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dec P9 configuration
Dec P9 configuration
2025-05-22 06:22:00 - last edited 2025-06-23 02:57:30

Hi, my Deco P9 has three devices. I use it in AP mode with one device connected to the BT router by Ethernet.

i would like to place one of these devices 100 metres away in my garden studio. I have an Ethernet cable running directly from the house router to the studio. Can I connect the third device via that cable to provide wi-fi to the studio?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Dec P9 configuration-Solution
2025-05-23 07:19:14 - last edited 2025-06-23 02:57:30

Hi @JohnEe,

Thank you for contacting our community.

 

Yes, if you want to add the third unit, please refer to How to add an additional unit to your Deco network

You can try to add the third unit to the existing deco network near the main deco first, and then move it to the studio.

 

Best Regards~

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More △New Firmware for Archer BE260/Archer BE400 to Support VPN Merge, New ECO Mode, and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Dec P9 configuration-Solution
2025-05-23 07:19:14 - last edited 2025-06-23 02:57:30

Hi @JohnEe,

Thank you for contacting our community.

 

Yes, if you want to add the third unit, please refer to How to add an additional unit to your Deco network

You can try to add the third unit to the existing deco network near the main deco first, and then move it to the studio.

 

Best Regards~

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More △New Firmware for Archer BE260/Archer BE400 to Support VPN Merge, New ECO Mode, and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 177

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.