Devices stuck on "ADOPTING"
Hi, i upgrade controller OC200v1 to latest versions, after than that i tried to update firmware of my two devices EAP610 from firmware section. But something is not going good, it seems firmware update fails and devices are stuck in "ADOPTING" and i cannot do any operation. Tried to swith off/on devicers, but nothing change!
Maybe devices stucked in "ADOPOTING" after controller upgrade, i didn't checked it.
What i should do?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I can see EAPs have now 192.168.0.254 ip address, that is different subnet then before and different respect OC200. Why they are not getting DHCP address?
- Copy Link
- Report Inappropriate Content
Checked from my dhcp server, they send DHCPDISCOVER but not DHCPREQUEST. I suspect this is a bug of new firmware version.
- Copy Link
- Report Inappropriate Content
Ok, i had to came back to 1.5.0 firmware to restore all.
Version 1.6.0 Build 20250507 Rel. 66340 don't allow device to get IP trough DHCP and device get fallback ip 192.168.0.254.
- Copy Link
- Report Inappropriate Content
Hi @Antony23
Where did you get the 1.6.0 version for EAP610 V3?
Or are you saying the pre-release version 1.8.50 from the following post?
EAP610 | EAP613 Pre-release Firmware Adapted to Omada Controller v6.1 (Released on 4th Jul, 2025)
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi @Antony23
Hope this message finds you well.
We are very concerned about your feedback. Has the issue been resolved?
If not, we had created a support email to you to follow up it more efficiently. The case ID is TKID250758741.
Please check your email inbox. Thanks.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 199
Replies: 6
Voters 0
No one has voted for it yet.