Background:

 

This post provides a configuration guide on VoIP.

 

This Article Applies to:

 

Omada routers with VoIP capability.  Especially, the DR- series models.

 

3. If your provider is NOT listed, select Other. Then, manually configure your VoIP settings.

 

Phone Number: The number you use to dial and answer.
Registrar Address: Usually a domain name of the VoIP register server, if not, an IP address.
Authentication ID and Password: Not necessary information, but if you have them, fill them in.

 

Attention! For Advanced parameters, if the VoIP provider does not provide this information, please click OK directly.

 

Registrar Port: Typically 5060, unless the VoIP provider specifies a different port.

SIP Proxy: Usually the domain name of the SIP Proxy Server, if not, an IP address.

SIP Proxy Port: Typically 5060, unless the VoIP provider specifies a different port.

Outbound Proxy: Usually the domain name of the Outbound Proxy Server, if not, an IP address.

Outbound Proxy Port: Typically 5060, unless the VoIP provider specifies a different port.

Register via Outbound Proxy: Typically not required to enable. By default, it is enabled. You can consult with your provider regarding this setting. 

 

 

Update Log:

 

Aug 13th, 2025:

Release of the article.

 

Recommended Threads:

 

Get the Latest Firmware Releases for Omada Routers Here - Subscribe for Updates

Get the Latest Omada SDN Controller Releases Here - Subscribe for Updates

 

Feedback:

 

• If this was helpful, welcome to give us Kudos by clicking the upward triangle below.
• If there is anything unclear in this solution post, please feel free to comment below.

 

Thank you in advance for your valuable feedback!

 

------------------------------------------------------------------------------------------------

Have other off-topic issues to report? 

Welcome to > Start a New Thread < and elaborate on the issue for assistance.