I just finished setting up a separate management VLAN (10) for the controller, switches, and APs.  In the devices list, the gateway is still displayed with its default address (192.168.0.1) but the rest of the devices are displayed with their 192.168.10.x addresses.  So far, OK.

In viewing the topology map, if I select any VLAN under Network Filter then all the devices and clients associated with that VLAN are highlighted.  However, when I select the Mgmt (10) VLAN, the controller and the APs are not highlighted, only the gateway and switches are highlighted.  Is this normal?  The only changes here have been adding the management VLAN and upgrading the controller firmware (only a few minutes ago).

Update (02-11-25):

After several issues with other VLANs not connecting properly to the internet, I have gone back to using the default VLAN as the management VLAN.  I did, however, make one change by changing the VLAN ID from 1 to 10.  Everything is working smoothly now.  I still have a problem with the topology map which I did not have before upgrading the controller firmware.  If I select the Mgmt (Default) VLAN, everything on that VLAN is highlighted except the controller and my EAP610.  The EAP650-Desktop APs are highlighted OK.  Additionally, when hovering the mouse over the controller, the Model and IP Address are no longer displayed, only its MAC address.  Perhaps the limited info on the controller is something new in the latest firmware update.  The EAP610 does show everything correctly.  Both the controller and the EAP610 are definitely on the default VLAN and I believe that both should be highlighted.  Attached is a snapshot.  Everything has been force provisioned and rebooted several times but the issue continues.  I have even waited overnight to see if things would clear up but there has been no change.  It is not a big issue but it is something that needs corrected.