Site-to-site and client-to-site VPN
Hi!
I have two sites (A and B) connected to each other via IPsec manual and completely managed by an Omada Software Controller located in Site A.
In both sites I use an ER707-M2 as gateway.
Now I have the requirement to add a client-to-site VPN, so clients can connect from remote.
However, adding an L2TP over IPsec server to site A in combination with the existing VPN seems impossible due to incompatible IPsec settings.
Is there any way to make this combination of site-to-site and client-to-site VPN work?
Thank you very much in advance!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
You can refer to this article for configuration:How to configure PPTP/L2TP/OpenVPN Client to access peer server through site-to-site VPN using business router
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@GRL Thanks for your reply.
So, I assume that changing to L2TP over IPsec would the a good solution in this case.
Can you tell me, if first changing the gateway in site B to be the L2TP client, then the gateway in site A to be the L2TP server will work without resetting any of the devices?
Or do you know a better way to change the setup without resetting?
Thanks again!
- Copy Link
- Report Inappropriate Content
L2TP wont work for remote sites that need omada management as it NATs the IP addresses , remote sites can only be managed over SD-WAN or IPsec
- Copy Link
- Report Inappropriate Content
You can refer to this article for configuration:How to configure PPTP/L2TP/OpenVPN Client to access peer server through site-to-site VPN using business router
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 270
Replies: 5
Voters 0
No one has voted for it yet.