Wireguard on Omada Controller + Windows PC OK but can't ping LAN through Wireguard tunnel
Hello
I have setup the Wireguard
I have set this up using the guide https://community.tp-link.com/en/business/forum/topic/619652
But after I have activate the tunnel whick works fine I tried to ping the router for example 192.168.123.254 or even other devices in the network 192.168.123.xx and get no respons. What am I doing wrong or what am I forgetting to do?
It must be something I forget I think but I've tried so many things and searched so many tips and tricks on the internet but I can't get it working. The tunnel is active but it stops there. Something with the listen port 52191 on the interface but I configured port 51820 on the Wireguard ?
it looks correct, so if you don't have any port forward to wireguard then it should work, you have to remember that even if everything is wrong in the configuration file wireguard will connect. there is no control on whether you are connected or not. but look in the omada console if you are connected. you will find this under vpn status
Look at the LAST HANDSHAKE date and time, if there is nothing there then you have not been able to connect.
I have also seen in some cases that Address = with /24 can cause problems, try with /32 like this Address = 192.168.124.2/32
MR.S wrote
Change wireguard server ip to 192.168.124.1 if you dont have this ip, in peer section on server sett peer ip to 192.168.124.2/32
and client file is like that.
If I want to make a new wireguard connection on another pc do I have to create also a new Wireguard on the Omada and a new peer with different listen ports or can I use the same?