RE210 not connecting after set-up

Eoin12

a week ago

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2026-01-05

RE210 not connecting after set-up

a week ago

Model: RE210

Hardware Version:

Firmware Version:

Just changed internet provider and setting up on new wifi network, but unable to complete the set-up. Tried a few times but no luck.

I factory reset the RE210 unit, and connected to it with through the open wifi network it created. Followed the steps in the manual to quick set-up, but after completion the unit just has the power LED on, and no 2.4G/5G/WPS LEDs, and the network hasn't been extended. Have left it powered for a good 20+ mins and no change. The open network has dissappeared, so I know its got at least partly through the set-up (however it means I can no longer connect to it).

Any ideas?

1 Reply

Joseph-TP

Thursday

Posts: 5323

Helpful: 343

Solutions: 2059

Stories: 0

Registered: 2024-06-22

Re:RE210 not connecting after set-up

Thursday

Hello @Eoin12 ,

Thanks for contacting our community.

Please ensure Proper Reset: Press and hold the RESET button (using a pin) for about 1 second until all LEDs flash. This will restore the extender to factory defaults.
After resetting, place your device close to the extender for setup. For a step-by-step video guide, you can visit the Setup Video.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: △New Firmware Update for Archer BE260/Archer BE400 to Support VPN Merge, New ECO Mode, and More △Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN △Tether KidShield Test Recruitment - Safeguarding Children's Online Experience If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.

RE210 not connecting after set-up

RE210 not connecting after set-up

Information

Voters 0

Tags