Hello.

I have updated firmware within the last three weeks and I am trying to enable IPV6.

After a lot of searching I have seen screengrabs (including from on here) which show a simple line under "general" saying Enable IPV6 [ ]

I do not have this however. I can only assume it is because I am configuring this locally and/or the new firmware is laid out differently.

Please can someone give an "idiots guide" for me to enable this to work with IPV6 - I have had another router which really was about as simple as clicing "Enable" and then it worked. The ER707-M2 works fine with IPV4 but I need to work out how to handle the static IPV6 address I am offered from Aquiss (UK 2.5gbit broadband supplier on pppoe and DHCPV6 for IPV6).

Even if there is an update manual that correlates to what the firmware displays will do - as I can then copy the manual into Claude and ask it to help me set it up.

At the moment though, Google, AI and dogged determination are not getting me very far!

Help please, if you can.

Many thanks
Mark