Business CommunityControllersHardware Controllers Omada SDN Controller 6.2.10 Pre-Release Firmware (Update on 30th Apr, 2026)
Controllers

Early Access Hardware Controllers Omada SDN Controller 6.2.10 Pre-Release Firmware (Update on 30th Apr, 2026)

1234

Early Access Hardware Controllers Omada SDN Controller 6.2.10 Pre-Release Firmware (Update on 30th Apr, 2026)

33 Reply
Re:Hardware Controllers Omada SDN Controller 6.2.10 Pre-Release Firmware (Update on 21st Apr, 2026)
a week ago

Hi  @Vishlamba 

Thanks for the updates. 

Does the situation persist? To further analyze the cause, I have created a support ticket for this case, and the case ID is TKID260459566.

Please kindly check your email inbox and get back to us. Thanks.

Vishlamba wrote

  @Vincent-TP Hi

 

Please me my answer:-

1. How about the display on the controller's web interface? Are they also shown as offline?: Yes they show offline in the web interface also. 

2. Is this happening on all clients? Or are there still some clients showing as online? :- Its only happening to a few say 5 to 10. Rest all stay online.  

3. What's the firmware version for the switches and EAPs? Is this happening both on wired and wireless clients? Attaching the complete list below, and yes it happens to both wired and wirless clients. Thanks

 

 

 

Wish you a happy life and smooth network usage!  >Get the Latest Omada SDN Controller Releases Here< >Get the Latest Firmware Releases for Omada Routers Here< >Experience the Latest Omada EAP Firmware<
0
0
#32
Re:Hardware Controllers Omada SDN Controller 6.2.10 Pre-Release Firmware (Update on 30th Apr, 2026)
13 hours ago - last edited 3 hours ago

  @Vincent-TP 

 

6.2.10.17 on OC300 seems to be struggling with firmware updates of devices

 

For example

Controller IP 192.168.0.254 /23

Switch IP 192.168.1.253 /23

 

OC is directly connected to this switch too.

 

Same subnet, no ACL restrictions on ports etc on management vlan - firmware upload reached 100% very slowly, it never gets to the point of "Firmware Obtained, updating" and the device on device list just stays on UPDATING for about 10 minutes before going disconnected, then connected again, on original firmware version.

 

I had a remote switch fail in a similar manner (port forward adoption) over several attempts

 

Another remote site (VPN adoption) switch upgrade worked fine

 

EDIT:

After many attempts all my switchs have now been updated to todays builds.  Not sure if the issue is with controller not actually pushing the updates (but saying it is) or somethign about the switch firmwares not accepting them unless you reboot the switch and immediately try again

 

 

0
0
#33
Re:Hardware Controllers Omada SDN Controller 6.2.10 Pre-Release Firmware (Update on 30th Apr, 2026)
10 hours ago - last edited 10 hours ago

  @Vincent-TP 

Hi,

I have just updated my oc200 to this firmware today, as one can see :
6.2.10.151.40.15 Build 20260417 Rel.51685

 

However approximately half on button/functionalities does no longer work.
- not even the firmware "button" in the left bar in global view works. - Then it is diffuelt to update the device.

 

Nor is my client list availiable.. Device and Network config also does not work.. This is not good!

 

Is there any work around..

 

Best regards,

Frank

0
0
#34
1234
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.