Omada Controller 3.1.4 (Windows) has been released.

Omada Controller 3.1.4 (Windows) has been released.

12 Reply
Re:Re: Omada Controller 3.1.4 (Windows) has been released.
2019-07-25 02:50:35

Hi @R1D2 ,

 

About your question, we had a test today. We set EAP in 192.168.1.1/24, OC200 in 192.168.2.1/24, then we enabled Guest Network in the SSID, the clients cannot access the OC200 (192.168.2.4), then we set Access Control for the SSId, and then we can ping the OC200 successfully. So we didn't reproduce your issue. We recommend you to have a test agian.

 

Captive Portal runs on a router which is connected to both subnets (multi-homed host).

We can set portal on the PC200 and the clients can authenticate successfully. You say the portal runs on a router, we don't understand it.

 

You mentioned the SSID Isolation, we will add this to our suggestion list, thank you for your feedback.

  0  
  0  
#18
Options
Re: Omada Controller 3.1.4 (Windows) has been released.
2019-07-28 14:44:31

Hello forrest,

 

thank you for your reply. Could it be that the effect depends on the firmware (EAP225-Outdoor)? I did test v1.0.0 (pre-installed), v1.3.0 and v1.5.0. They seem to have different semantics regarding ACLs. With version 1.0.5 it works so far.

 

Regarding Captive Portal: yes, we use our own Captive Portal software running on the router b/c we need detailed possibility of intervention due to legal regulations (german TMG law). The router can be any device, either our own x86-based hardware as shown below, but also any other router, even an Archer WiFi router or an UBNT EdgeRouter running our own firmware.

 

Following diagram outlines the most common topology, another one is the placement of OC200 in the WAN zone if the WAN zone is behind another router (e.g. from the ISP) instead of just a modem:

 

 

Firewall and ACLs are on the router. ACLs on EAPs are not needed in this topology. I really would appreciate if you could enable Client Isolation setting in Omada Controller again.

 

Thanks for your consideration! Much appreciated.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#19
Options