EAP 330 keep disconecting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP 330 keep disconecting

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP 330 keep disconecting
EAP 330 keep disconecting
2019-11-11 08:12:19 - last edited 2019-11-11 08:33:06
Model: EAP330  
Hardware Version: V2
Firmware Version: 1.4.0

Hi, I have an Access Point network of 12 units with EAP330 access points. they are managed by Software could controller 3.0.5 installed on a windows server, and I have access points constantly disconnecting. Why does it happen and why the AP does not appear on the pending Ap's after forgetting it.

 

This is happening in almost all of the networks I have (5 networks, 1 for each individual client).

 

Thank You for Your time.

  0      
  0      
#1
Options
2 Reply
Re:EAP 330 keep disconecting
2019-11-12 00:44:02 - last edited 2019-11-12 00:44:16

@RCGC 

 

As you said, the Omada Controller is installed on a windows server but your access points constantly disconnect from the Omada Controller, and even they don't show on the pending list. 

 

Normally, the disconnection issue is related to the network. After you adopt the EAPs on the Omada Controller, does the Controller and these EAPs have a good connection all the time? And are the Controller and EAPs  in the same subnet? Can you ping these APs on the Controller host? We recommend you to check the network cable. 

  0  
  0  
#2
Options
Re:EAP 330 keep disconecting
2019-11-12 01:55:29

@forrest It those ping the "Disconnected" AP.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1098

Replies: 2

Related Articles