CONFIGURATION OF TPLINK CPE510 FOR WIRELESS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CONFIGURATION OF TPLINK CPE510 FOR WIRELESS

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CONFIGURATION OF TPLINK CPE510 FOR WIRELESS
CONFIGURATION OF TPLINK CPE510 FOR WIRELESS
2019-12-20 07:33:42 - last edited 2019-12-20 07:44:35
Model: CPE510  
Hardware Version:
Firmware Version:

Good morning

 

i have TPLINK CPE510  I HAVE challenge to configure it as wireless access point for my phone, laptop. the types of phones am using are both 3g and 4g. kindly assist me with the best step by step for configuration.

  0      
  0      
#1
Options
1 Reply
Re:CONFIGURATION OF TPLINK CPE510 FOR WIRELESS
2019-12-20 11:41:50 - last edited 2019-12-20 11:52:23

 

bukenya wrote

i have TPLINK CPE510  I HAVE challenge to configure it as wireless access point for my phone, laptop.

 

CPEs are designed for long-range WiFi links between two CPEs. They have directional antennas (45º beam width) and thus are not meant to supply devices such as smartphones or tablets. A much better device to serve smartphones and clients is the EAP225-Outdoor, which have omnidirectional antennas (360º beam width).

 

Using a CPE to serve smartphones/tablets is much like using a pointed beam from a garden hose instead of a wide shower to spread the water around in every direction. You would have to target the smartphones exactly with the CPEs while the clients are moving around.

 

If you insist to use a CPE510 as a standard AP for clients, use the wizard to set up the minimal confguration of the CPE in AP mode, but expect problems with WLAN connectivity on the clients.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 970

Replies: 1

Related Articles