No channel for EAP245 but Wall Access Point Fine

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

No channel for EAP245 but Wall Access Point Fine

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No channel for EAP245 but Wall Access Point Fine
No channel for EAP245 but Wall Access Point Fine
2020-07-27 10:17:39
Model: EAP245  
Hardware Version: V3
Firmware Version: 2.20.0 Build 20200423

I have setup a network with 2 access points,a ceiling EAP245 and a wall access point 225.   All clients seem to be connecting to the Wall Point.   In the Omada controller interface under access points, the two are listed the wall one has channels listed (1(2.4G, 40(5G)) but the EAP245 just has "--".   I have tried setting it to specific channels, turning down the Tx Power, rebooting etc and nothing seems to work.

 

any ideas?

  0      
  0      
#1
Options
3 Reply
Re:No channel for EAP245 but Wall Access Point Fine
2020-07-27 17:43:29

@richb78uk, did you assign the EAP245 to a WLAN group in the AP's configurstion menu?

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:No channel for EAP245 but Wall Access Point Fine
2021-01-12 08:08:30

@richb78uk I am having this exact same issue with the wall access point. Did you find a fix?

 

Thanks

  0  
  0  
#7
Options
Re:No channel for EAP245 but Wall Access Point Fine
2021-01-15 07:52:31

Dear @rsmith1749,


I noticed that you have raised the problem in a new thread and Philbert has answered in this post.

 

Please check the version of your Omada Controller, ensure the EAP firmware is compatible with the controller.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#8
Options