Switch TL-SG1024DE isolation
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
We have 3 x TL-SG1024DE switches installed in hotel (1 on each floor) which give internet to our guest rooms, 2 ports per room connected to RJ45 wall sockets, how can i isolate so that ports from one room dont "see" ports of other rooms. Port 1 is our uplink. Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Nek,
how can i isolate so that ports from one room dont "see" ports of other rooms. Port 1 is our uplink. Thanks
The 802.1Q VLAN may help. Devices from different VLANs cannot achieve Layer 2 communication, thus you can group and isolate devices to meet your demands.
Here is the example guide for your reference.
How to configure 802.1Q VLAN on the TP-Link Easy Smart/Unmanaged Pro Switches
Hope this information is helpful. Best Regards!
- Copy Link
- Report Inappropriate Content
Dear @Nek,
how can i isolate so that ports from one room dont "see" ports of other rooms. Port 1 is our uplink. Thanks
The 802.1Q VLAN may help. Devices from different VLANs cannot achieve Layer 2 communication, thus you can group and isolate devices to meet your demands.
Here is the example guide for your reference.
How to configure 802.1Q VLAN on the TP-Link Easy Smart/Unmanaged Pro Switches
Hope this information is helpful. Best Regards!
- Copy Link
- Report Inappropriate Content
Thanks Fae, i have done as described but how can i be sure it is isolated? I ping some devices with static ips from the other switches and packages receive and are sent without loss. i have also this software that scans ips in the network and it can find still all. Is this how it should be?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1299
Replies: 4
Voters 0
No one has voted for it yet.