Reinstall Omada Controller and not reset all the AP's?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
So I had to reformat my computer where my controller runs - now how do I get it to reconnect to the 3AP's that are already set up?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@jcwillia1, you cannot »re-import« settings from EAPs into a controller.
You can only restore a setup from a former backup into a new controller, which is the central authority for all setups.
If you have no backup, you need to manually set up the controller and adopt the EAPs again (after having reset the EAPs).
There is no other way to get them connected again to a freshly installed controller.
- Copy Link
- Report Inappropriate Content
@jcwillia1, you cannot »re-import« settings from EAPs into a controller.
You can only restore a setup from a former backup into a new controller, which is the central authority for all setups.
If you have no backup, you need to manually set up the controller and adopt the EAPs again (after having reset the EAPs).
There is no other way to get them connected again to a freshly installed controller.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@jcwillia1, for which controller version? V3.2.x? Please see the Controller User's Guide, chapter 6.4 / 6.5.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2308
Replies: 4
Voters 0
No one has voted for it yet.