VLAN (PVID) binding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

VLAN (PVID) binding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VLAN (PVID) binding
VLAN (PVID) binding
2020-11-12 22:32:47 - last edited 2020-11-23 08:31:45
Model: TL-SG1016DE  
Hardware Version: V3
Firmware Version: 1.0.1 Build 20180629 Rel.58355

Router is configured for DHCP on VLAN ID 100 on port 15 which is connected to Switch 2 port 15.

 

I assume I need to configure port 15 as tagged with PVID 100 and should be combined with port 13 what should be untagged.

But I don't get it working.

  0      
  0      
#1
Options
1 Accepted Solution
Re:VLAN (PVID) binding -Solution
2020-11-20 10:41:03 - last edited 2020-11-23 08:31:45

@Fae ,

Hi ,

 

I had it configured as describerd above. After restart of the Switch it worked.

I's strange that a reboot of the switch was needed to get it worked.

 

Kind regards,

 Johan

Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:VLAN (PVID) binding
2020-11-20 10:38:01 - last edited 2020-11-20 10:40:43

Dear @JohanV,

 

I assume I need to configure port 15 as tagged with PVID 100 and should be combined with port 13 what should be untagged.

But I don't get it working.

 

So the purpose is to get Port15 and Port13 to communicate with the Router over VLAN 100.

I assume the port13 will be connected to a non-VLAN aware device, right?

 

If the Port15 on the Router is configured with VLAN 100 tagged, then you need to configure VLAN on the switch as the following:

1) Create VLAN100, select Port15 as Tagged, Port13 as Untagged; 

2) Configure the PVID for Port13 as 100, leave others as the default value; 

3) Test the connection.

 

Here is the configuration guide of VLAN for your reference. https://www.tp-link.com/support/faq/788/

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:VLAN (PVID) binding -Solution
2020-11-20 10:41:03 - last edited 2020-11-23 08:31:45

@Fae ,

Hi ,

 

I had it configured as describerd above. After restart of the Switch it worked.

I's strange that a reboot of the switch was needed to get it worked.

 

Kind regards,

 Johan

Recommended Solution
  0  
  0  
#3
Options