New Wired Network
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi guys, please, help.
I have OC200, TL-SG2428P, EAP225 and TL-R605.
I adopted everything. Now I want to create several vlan networks.
I create New LAN. Interface 10.13.50.1/24, configure DHCP Range
then I create SSID with VLAN50
My EAP225 shows SSID vlan50, I connect to it, but I do not receive IP-address. (It is 169.254.x.x). Why?
I guess, TL-R605 must give it to me. Should I change Profile on switch somehow of what?
If I make one of the switch port as untagged 50/pvi 50 by changing profile, I still do not receive any IP-address, if connect there.
I even check by SSH and I see
#
interface gigabitEthernet 1/0/5
switchport general allowed vlan 50 untagged
switchport pvid 50
no switchport general allowed vlan 1
dot1x port-control authorized-force
no spanning-tree bpduflood
lldp med-status
loopback-detection config process-mode port-based recovery-mode auto
loopback-detection
#
while my TL-R605 is connected to
#
interface gigabitEthernet 1/0/3
switchport general allowed vlan 50-52 tagged
dot1x port-control authorized-force
no spanning-tree bpduflood
lldp med-status
loopback-detection config process-mode port-based recovery-mode auto
loopback-detection
#
It only give IPs from default range of 192.168.0.1 for the ports like gi1/0/3, which belongs to profile ALL (with vlan 1)
@Mitya still I have a question though.
I changed Management VLAN for switch, AP and moved my OC200 to untagged vlan 50 port.
Now my TL-R605 is in Disconnected status, because it shows IP 192.168.0.1 and I can't change it to 10.13.50.1/24, and it is not changed automatically in controller.
How can I now force my controller to connect to TL-R605 not by 192.168.0.1, but by 10.13.50.1/24, the New LAN Interface, which I created above?
@Fae In fact, I can ping it from my laptop and OC200 also must be able to do so, however, it is still "heartbeat missed" and then "disconnected".So, Intervlan routing works.
Profile on port for TL-R605 is ALL, so it has vlan 1 untagged/pvid 1 and tagged 50-52 vlans.
OC200 - untagged 50
AP - ALL, so it is tagged 50-52 and untagged 1/pvid 1
Laptop - untagged 50.
I thought you can change somehow default IP Interface, which would be checked, but it seems you can't. You know, I seems to fix it by changing default LAN Network from 192.168.0.1/24 to the needed one (vlan 50). So, I didn't create new network with vlan50, but changed default LAN. Then I needed to reboot it in some weird order and now I have, what I need, but it is very unfriendly, as I could see.
